AC220V Outdoor LED Module · IP65 · 6515-2835-3D · 1.8W · 160° · White 白光 8000-10000K · 100pcs/pack

AC220V, no driver needed — connects directly to mains, no transformer required Saves cost and space — no driver to buy, size, or house inside the sign Wide 185-275V input (8722) — stable operation through voltage fluctuation IP65 waterproof — fully sealed injection housing for outdoor signage 3 LEDs with optical lenses — even light spread across the sign face Wide beam — 160° on the 6515, 170° on the 8722 High output option — 3W / 250LM on the 8722 for demanding jobs CE & RoHS certified — meets recognised safety and materials standards Self-adhesive backing — peel and stick straight onto the surface, no drilling needed Fixing holes provided — add screws where you want extra hold Clear L/N wiring — with high-voltage warning marked on the housing Chains of 20 — fast layout, cut the chain where you need it Perfect for: channel letters & 3D letters, logo letters & signboards, advertising lightboxes, shopfront signage, large outdoor illuminated displays

1. Have a qualified electrician install it. These modules run at AC220V mains voltage. Installation and wiring must be carried out by a qualified person using properly rated wiring, in line with local regulations. 2. Switch off and isolate first. Always cut and isolate the mains supply before any wiring or servicing work. 3. Cut the chain to length. Separate the chain at the wire between modules to suit your sign. 4. Clean the surface. Wipe the inside of the letter or lightbox clean and dry before sticking anything down — dust and oil are what cause modules to drop off later. 5. Peel and stick. Most modules come with the double-sided adhesive already applied — peel off the backing paper and press each module firmly into place. Space them evenly in rows for a smooth, spot-free face. 6. Add screws if needed. For rough or dusty surfaces, or anywhere the modules take vibration or heat, run a screw through the fixing holes to secure them properly. 7. Wire to L and N. Connect the chain to the mains supply following the L/N marking on the modules. Keep the wiring convention consistent across the whole installation. 8. Enclose everything. Because these carry mains voltage, the modules must be installed inside enclosed signage and never left exposed where they can be touched. Seal all wire joints thoroughly against moisture. 9. Check before closing up. Power on and confirm even illumination before fitting the face panel. Safety: 220V is high voltage and can be fatal. All connections must be enclosed, insulated, and out of reach. If you are not qualified to work on mains, have an electrician do the connection.